enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

3. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   Proper use requires that the screwdriver's tip engage the head of a screw of the same size and type designation as the screwdriver tip. Screwdriver tips are available in a wide variety of types and sizes (List of screw drives). The two most common are the simple 'blade'-type for slotted screws, and Phillips, generically called "cross-recess ...

4. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   Drill points for the smallest 133/135 size screwdriver; adapters to adapt push drill size drill point sets to the three sizes of screwdriver chuck size; countersinks; screwdriver tips holding with screw holding feature; Phillips screwdriver tips in various sizes (Ph#1 to Ph#3 in 5/16" and 9/32" shank models, Ph#1 and Ph#2 sizes only for the 7/ ...

5. Phillips screwdriver - Wikipedia

   en.wikipedia.org/?title=Phillips_screwdriver&...

   move to sidebar hide. From Wikipedia, the free encyclopedia

6. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Screwdriver bits in different sizes for Robertson screws. When Henry Ford tried the Robertson screws, he found that they saved considerable time in Model T production. When Robertson refused to license the design, Ford realized that the supply of screws would not be guaranteed, and chose to limit their use to his Canadian division. [4] [5] [6]

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...