enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Countertop - Wikipedia

   en.wikipedia.org/wiki/Countertop

   The edge treatment for solid-surface countertops can be very elaborate. The material itself is usually only about 12 mm (1 ⁄ 2 in) thick so an edge is usually created by stacking up two or three layers of the material. The built-up edge then can be shaped to a rounded edge or an ogee. Fancier edge treatments are more expensive.

3. Japanese kitchen knife - Wikipedia

   en.wikipedia.org/wiki/Japanese_kitchen_knife

   They have an omote, (an edge on the right for right-handers); a shinogi, (where the front bevel meets the flat of the blade face); and an urasuki, (a hollow backside that releases food). These knives are usually a little thicker at the spine and body than Japanese double bevels, but are thinner right behind the edge.

4. Sharpening stone - Wikipedia

   en.wikipedia.org/wiki/Sharpening_stone

   The term is based on the word "whet", which means to sharpen a blade, [3] [4] not on the word "wet". The verb nowadays to describe the process of using a sharpening stone for a knife is simply to sharpen, but the older term to whet is still sometimes used, though so rare in this sense that it is no longer mentioned in, for example, the Oxford Living Dictionaries.

5. Norovirus Is Surging Across The Country. Here Are The ... - AOL

   www.aol.com/norovirus-surging-across-country...

   Norovirus cases are surging in the US, the CDC says. Here are the symptoms to look for, plus how long you're contagious for, per an infectious disease doctor.

6. 2 Teenagers Dead and Sister in Critical Condition after Car ...

   www.aol.com/2-teenagers-dead-sister-critical...

   Giselle Smith and Semaj Morris, 17, were both killed on Wednesday, Dec. 11, with Smith's sister Paris Kiper in critical condition

7. Built up edge - Wikipedia

   en.wikipedia.org/wiki/Built_up_edge

   The built up edge effectively changes tool geometry and rake steepness. It also reduces the contact area between the chip and the cutting tool, [1] leading to: A reduction in the power demand of the cutting operation. [1] Slight increase in tool life, since the cutting is partly being done by the built up edge rather than the tool itself. [4]