Search results
Results from the WOW.Com Content Network
The conversion procedure for some units (for example, the Mach unit of speed) are built into Module:Convert as they are too complex to be specified in a table. That is indicated by entering a code (which must be the same as used in the module) in the Extra column.
Using Boyle's law, the equivalent GGE at 3,600 psi (25 MPa) is 0.51 cubic feet (14 litres; 3.8 US gallons). The National Conference of Weights & Measurements (NCWM) has developed a standard unit of measurement for compressed natural gas, defined in the NIST Handbook 44 Appendix D as follows: "1 Gasoline [US] gallon equivalent (GGE) means 2.567 ...
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
Volume may be measured either in terms of units of cubic length or with specific volume units. The units of cubic length (the cubic inch, cubic foot, cubic mile, etc.) are the same in the imperial and US customary systems, but they differ in their specific units of volume (the bushel, gallon, fluid ounce, etc.). The US customary system has one ...
Water volume for sinks, bathtubs, ponds, swimming pools, etc., is usually stated in gallons or cubic feet. Quantities of gases are usually given in cubic feet (at one atmosphere). Minims, drams, gill, and pottle are rarely used currently. The gill is often referred to as a "half-cup". The pottle is often referred to as a "half-gallon".
Oil conversion factor from m³ to bbl (or stb) is 6.28981100 Gas conversion factor from standard m³ to scf is 35.314666721 Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
The Winchester bushel is the volume of a cylinder 18.5 in (470 mm) in diameter and 8 in (200 mm) high, which gives an irrational number of approximately 2150.4202 cubic inches. [4] The modern American or US bushel is a variant of this, rounded to exactly 2150.42 cubic inches, less than one part per ten million less. [ 5 ]
This regulation defines a standard cubic foot, for compressed or liquefied gases in refillable cylinders other than LPG by, "A standard cubic foot of gas is defined as a cubic foot at a temperature of 21 °C (70 °F) and a pressure of 101.325 kilopascals [kPa] (14.696 psia)".