Search results
Results from the WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
All Newport models including wagons had a larger standard engine for 1965: The 3.375 inch stroke LB engine was bored to 4.25 inches yielding 383 cubic inches. With a 2BBL carburetor and single exhaust, the regular fuel 383 produced 270 HP. A premium fuel 383 engine with 4BBL and dual exhausts producing 305 HP was an available option.
Jensen Motors used Chrysler V8 engines for the Interceptor, starting with the 6,276 cc (383 c.i.) with optional manual (Mark I, 22 built) or TorqueFlite automatic transmissions driving the rear wheels through a limited slip differential in a conventional Salisbury rear axle. In 1970, the 383 c.i. produced 335 hp SAE gross, or 270 hp SAE net.
Muscle car versions were available starting in 1965 with the 383 and 426 wedge cu in (7.0 L) Chrysler RB engine, followed in 1966 by the powerful 426 cu in (7.0 L) Chrysler Hemi. Other performance models included the "Superbee", and featured, the 383 cu in (6.3 L) Magnum, among other engine options.
All C-V8s used big-block engines sourced from Chrysler; first the 361 and then, from 1964, the 330 bhp (246 kW) 383 in³. Most of the cars had three-speed Chrysler Torqueflite automatic transmission, but seven Mk2 C-V8s were produced with the 6-litre engine and four-speed manual gearbox, followed by two manual Mk3s. The engine is entirely set ...
The standard-equipment engine on the 1969 Monaco is Chrysler's 245-horsepower (183 kW) B-block 383 cu in (6.3 L) V8 engine with a two-barrel 2245 Holley carburetor. Buyers could order the 383 with a four-barrel carburetor that increased power to 330 hp (250 kW), or they could opt for the 375-horsepower (280 kW) 440 cu in (7.2 L) Magnum RB-block ...
Intended to deal with the troubles created by the low-production 426, of which only about 9,000 were built from 1966 to 1972), [4] as well as the different architectures of the higher-volume 383 cu in (6.3 L) and 400 cu in (6.6 L) B and 440 cu in (7.2 L) RB V8s, the ball-stud hemi was to be suitable for high-volume manufacture at low cost while ...
The "GEN-3" engines were available in Jeep utility vehicles starting in 1971. [3] It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5]