Search results
Results from the WOW.Com Content Network
Structure of an Ethernet packet, including the FCS that terminates the Ethernet frame [1] A frame check sequence (FCS) is an error-detecting code added to a frame in a communication protocol. Frames are used to send payload data from a source to a destination.
This frame may cause a collision at the remote end which cannot be detected by the transmitter, so the frame is not resent on the physical layer. Due to interference on the medium, its data is corrupted and frame check sequence fails, requiring recovery at a higher layer, if possible. [citation needed]
A frame is a series of bits generally composed of frame synchronization bits, the packet payload, and a frame check sequence. Examples are Ethernet frames, Point-to-Point Protocol (PPP) frames, Fibre Channel frames, and V.42 modem frames. Often, frames of several different sizes are nested inside each other.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
The end of a frame is signaled by a valid frame check sequence followed by loss of carrier or by a special symbol or sequence in the line coding scheme for a particular Ethernet physical layer, so the length of the frame does not always need to be encoded as a value in the Ethernet frame. However, as the minimum payload of an Ethernet frame is ...
Token Ring eliminates collision by the use of a single-use token and early token release to alleviate the down time. Legacy Ethernet alleviates collision by carrier-sense multiple access and by the use of an intelligent switch; primitive Ethernet devices like hubs could precipitate collisions due to repeating traffic blindly. [15]
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport
Any unique sequence which will not be interpreted by the secondaries will do, but the conventional one is a single all-zero byte. [9]: 44 This is a "runt frame" with an address of 0 (reserved, unused) and no control field or frame check sequence. (Secondaries capable of full-duplex operation also interpret this as a "shut-off sequence", forcing ...