Ads
related to: bolt codes grade chart
Search results
Results from the WOW.Com Content Network
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]
The length of a machine screw or bolt is indicated by an × and the length expressed in millimetres (e.g. M8-1.25×30 or M8×30). [citation needed] Tolerance classes defined in ISO 965-1 can be appended to these designations, if required (e.g. M500– 6g in external threads). External threads are designated by lowercase letter, g or h.
They are usually made of low grade steel, have a slot or Phillips drive, and are used to join sheet metal parts using a hex or square nut. [12] plow bolt: plough bolt: A plow bolt is bolt similar to a carriage bolt, except the head is flat or concave, and the underside of the head is a cone designed to fit in a countersunk recess.
Product grade A washers – with a hardness up to 300 HV designed for use with hexagon head bolts and nuts: Withdrawn: DIN EN ISO 7089, DIN EN ISO 7090: ISO 7089, ISO 7090: DIN 126: Product grade C washers – designed for use with hexagon head bolts and nut: Withdrawn: DIN EN ISO 7091: ISO 7091: DIN 127: Spring lock washers with square ends or ...
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
The SAE steel grades system is a standard alloy numbering system (SAE J1086 – Numbering Metals and Alloys) for steel grades maintained by SAE International. In the 1930s and 1940s, the American Iron and Steel Institute (AISI) and SAE were both involved in efforts to standardize such a numbering system for steels.
The numbers stamped on the head of the bolt are referred to the grade of the bolt used in certain application with the strength of a bolt. High-strength steel bolts usually have a hexagonal head with an ISO strength rating (called property class) stamped on the head. And the absence of marking/number indicates a lower grade bolt with low strength.
Ads
related to: bolt codes grade chart