Search results
Results from the WOW.Com Content Network
Criticality accidents are divided into one of two categories: Process accidents, where controls in place to prevent any criticality are breached;; Reactor accidents, which occur due to operator errors or other unintended events (e.g., during maintenance or fuel loading) in locations intended to achieve or approach criticality, such as nuclear power plants, nuclear reactors, and nuclear ...
More than 30 people were over-exposed to radiation when the starboard reactor cooling system failed and the reactor temp rose uncontrollably. Emergency repairs ordered by the captain successfully cooled the reactor and avoided meltdown, but exposed the workers to high levels of radiation. [17] 8 Radiation accident in Morocco: 1984 March
Failure to remove decay heat may cause the reactor core temperature to rise to dangerous levels and has caused nuclear accidents. The heat removal is usually achieved through several redundant and diverse systems, and the heat is often dissipated to an 'ultimate heat sink' which has a large capacity and requires no active power, though this ...
Radiation poisoning, also called "radiation sickness" or a "creeping dose", is a form of damage to organ tissue due to excessive exposure to ionizing radiation. The term is generally used to refer to acute problems caused by a large dosage of radiation in a short period, though this also has occurred with long-term exposure to low-level radiation.
In most reactors it takes the form of a sealed metallic or ceramic layer. It also serves to trap fission products, especially those that are gaseous at the reactor's operating temperature, such as krypton, xenon and iodine. Cladding does not constitute shielding, and must be developed such that it absorbs as little radiation as possible.
Not all of the heat in a nuclear reactor is generated by the chain reaction that a scram is designed to stop. For a reactor that is scrammed after holding a constant power level for an extended period (greater than 100 hrs), about 7% of the steady-state power will remain after initial shutdown due to fission product decay that cannot be stopped.
In nuclear accidents, a measure of the type and amount of radioactivity released, such as from a reactor containment failure, is known as the source term. The United States Nuclear Regulatory Commission defines this as "Types and amounts of radioactive or hazardous material released to the environment following an accident." [7]
On July 4, 1961, while K-19 was operating near southern Greenland, water pressure in the starboard nuclear reactor plummeted due to a coolant leak in an area of the reactor very difficult to access. The loss of coolant caused the reactor to begin to overheat, endangering the integrity of the control rods.