enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Milwaukee Tool - Wikipedia

   en.wikipedia.org/wiki/Milwaukee_Tool

   In 1991, Milwaukee released the Milwaukee Super Sawzall, a reciprocating saw with built-in counterbalance, a gear-protecting clutch, and five different patents. In the later 1990s, Milwaukee Electric Tool Corporation released a new range of miter saws and a lineup of 18-volt contractor cordless tools. [7]

3. Miter saw - Wikipedia

   en.wikipedia.org/wiki/Miter_saw

   A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...

4. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   These saws are characterized by a cast iron top on a full-length steel base, generally square in section, with radiused corners. Two 3 ⁄ 4-inch-wide (19 mm) miter slots (1 inch [25 mm] wide on the largest saws) are located parallel to the blade, one to the left of the blade and one to the right.

5. Reciprocating saw - Wikipedia

   en.wikipedia.org/wiki/Reciprocating_saw

   A reciprocating saw is a type of handheld, small, machine-powered saw, in which the cutting action is achieved through a push-and-pull ("reciprocating") or back-and-forth motion of the blade. The original trade name, Sawzall, is often used in the United States, where Milwaukee Electric Tool first produced a tool of this type in 1951. [1] [2]

6. Backsaw - Wikipedia

   en.wikipedia.org/wiki/Backsaw

   Tenon saws are commonly available with rip-filed teeth for rip cutting and cross-cut for cutting across the grain. Teeth are relatively fine, with 13 teeth per inch being a common size for the saw. Sash saw – name that seems to have been used in the 18th and 19th century for a smaller tenon saw, used in fabricating window sashes. The term is ...

7. Saw - Wikipedia

   en.wikipedia.org/wiki/Saw

   There is always one more point per inch than there are teeth per inch (e.g., a saw with 14 points per inch will have 13 teeth per inch, and a saw with 10 points per inch will have 9 teeth per inch). Some saws do not have the same number of teeth per inch throughout their entire length, but the vast majority do. Those with more teeth per inch at ...