Search results
Results from the WOW.Com Content Network
Plaster veneer (American English) or plaster skim (British English) is a construction methodology for surfacing interior walls, by applying a thin layer of plaster over a substrate—typically over specially formulated gypsum board base, similar in nature to drywall.
When used for new walls, joint compound effectively eliminates blemishes from the surface of drywall, such as fasteners, damage, or drywall tape. Joint compound is used to finish gypsum panel joints filled with paper or fiber joint tape, corner bead, trim and fasteners, and to skim coat. It is also convenient for patching holes, bumps, tears ...
The compound is allowed to air dry and then typically sanded smooth before painting. Alternatively, for a better finish, the entire wall may be given a skim coat, a thin layer (about 1 mm or 1 ⁄ 32 in) of finishing compound, to minimize the visual differences between the paper and mudded areas after painting.
The first coat or rendering is from 1 ⁄ 2 to 3 ⁄ 4 inches thick, and is mixed in the proportions of from one part of cement to two of sand to one part to five of sand. The finishing or setting coat is about 3 ⁄ 16 inches thick, and is worked with a hand float on the surface of the rendering, which must first be well wetted.
Titanium nitride (TiN; sometimes known as tinite) is an extremely hard ceramic material, often used as a physical vapor deposition (PVD) coating on titanium alloys, steel, carbide, and aluminium components to improve the substrate's surface properties.
Melamine cyanurate, also known as melamine–cyanuric acid adduct or melamine–cyanuric acid complex, is a crystalline complex formed from a 1:1 mixture of melamine and cyanuric acid.
TiB 2 does not occur naturally in the earth. Titanium diboride powder can be prepared by a variety of high-temperature methods, such as the direct reactions of titanium or its oxides/hydrides, with elemental boron over 1000 °C, carbothermal reduction by thermite reaction of titanium oxide and boron oxide, or hydrogen reduction of boron halides in the presence of the metal or its halides.
With a thick enough TGO, spalling of the coating may occur, which is a catastrophic mode of failure for TBCs. The use of such coatings would require additional coatings that are more oxidation resistant, such as alumina or mullite. [4] The bond coat is an oxidation-resistant metallic layer which is deposited directly on top of the metal substrate.