Search results
Results from the WOW.Com Content Network
These are to work with the car divisions to: Define hardware and system requirements. Develop design specifications for all hardware all hardware required. Review alternative designs and systems. Arrange to test and validate systems, which best suits the needs of all concerned. Monitor component design and release.
The vapors which are displaced from the fuel tank by the incoming fuel are routed via the vapor vent line to the canister and are absorbed by activated carbon. These canisters are made of either steel or plastic. The size of this canister is tailored to accommodate expected evaporative emissions.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
EGR valve the top of box on top of the inlet manifold of a Saab H engine in a 1987 Saab 90. In internal combustion engines, exhaust gas recirculation (EGR) is a nitrogen oxide (NO x) emissions reduction technique used in petrol/gasoline, diesel engines and some hydrogen engines. [1]
These blow-by gases, if not ventilated, inevitably condense and combine with the oil vapor present in the crankcase, forming oil sludge. Excessive crankcase pressure can furthermore lead to engine oil leaks past the crankshaft seals and other engine seals and gaskets. Therefore, it becomes imperative that a crankcase ventilation system be used.
The early fuel evaporator is a device found in some internal combustion engines with carburetors.It can sometimes be referred to as an electronic fuel evaporator. The device on a car, commonly referred to as an EFE heater, is located between the throttle body of the carburetor and the intake manifold as a gasket and contains a resistance grid that heats the air/fuel mixture.
Vice President Kamala Harris sat for a one-on-one interview with MSNBC host Stephanie Ruhle on Wednesday, hours after delivering a speech in Pittsburgh that laid out her economic priorities.
Indirect TPMS (iTPMS) systems do not use physical pressure sensors; they measure air pressures using software-based systems, which by evaluating and combining existing sensor signals such as wheel speeds, accelerometers, and driveline data to estimate and monitor the tire pressure without physical pressure sensors in the wheels.