Search results
Results from the WOW.Com Content Network
7-pin trailer connector according to ISO 1185/SAE J560 (Towing vehicle side) Physical design according to standard ISO 1185 [4] / SAE J560. [5] [6] The plug for SAE J560 is physically identical to the connector ISO 1185.
A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."
12 Volt 7-pin trailer connector ISO 7638-2 for ABS and EBS (Towing vehicle side) Physical design according to standard ISO 7638-2. [4] [6] [7] This connector is intended to be used for 12V ABS and EBS on heavy duty trailers. Identified by key tab on outer ring between pin 3 and 4. #
The trailer tongue (North America) or coupling (outside North America) slips over a trailer hitch ball attached to a receiver hitch mount or integral with the hitch. A larger, heavy-duty gooseneck ball size: 3 in (76.2 mm) is typically used for towing greater than 10,000 pounds (4.5 t), and this towing capacity falls outside of the scope of SAE ...
Karol Pollak was born in Sanok, Kingdom of Galicia and Lodomeria, part of the Austrian Empire. His father was Karol Pollak (1818–80), who was a printer, bookseller and publisher. The younger Karol worked as an electrician in his youth and showed great technical skills in it. In 1883 he was employed in the laboratory of a British company "The ...
Trailer connector according to NATO STANAG 4007. NATO uses a 12-pin connector [NATO 1] [NATO 2] according to STANAG 4007. [1] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.
ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system. It was developed in 1987 by Erich Jaeger [ 1 ] to replace older 7-pin plugs. Notes
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...