enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Vinyl ester resin - Wikipedia

   en.wikipedia.org/wiki/Vinyl_ester_resin

   This thermoset material can be used as an alternative to polyester and epoxy materials as the thermoset polymer matrix in composite materials, where its characteristics, strengths, and bulk cost are intermediate between polyester and epoxy. Vinyl ester has lower resin viscosity (approx. 200 cps) than polyester (approx. 500cps) and epoxy (approx ...

3. Iron-on - Wikipedia

   en.wikipedia.org/wiki/Iron-on

   There are primarily two types of iron-on labels: a form of material tape; and a form of vinyl similar to that used on graphic t-shirts. With the vinyl type the objective is to effectively melt the label onto the cloth so the label and garment become one, hence a permanent bond. The application of a label typically takes about 10–15 seconds ...

4. Cyanoacrylate - Wikipedia

   en.wikipedia.org/wiki/Cyanoacrylate

   Cyanoacrylate glue has a low shearing strength, which has led to its use as a temporary adhesive in cases where the piece needs to be sheared off later. Common examples include mounting a workpiece to a sacrificial glue block on a lathe , and tightening pins and bolts.

5. Self-adhesive plastic sheet - Wikipedia

   en.wikipedia.org/wiki/Self-adhesive_plastic_sheet

   Self-adhesive plastic sheet, known in the United Kingdom as sticky-backed plastic, is wide plastic sheet or film with an adhesive layer on one side, used as a surface coating for decorative purposes. It is typically smooth and shiny, but can also come in textured varieties, in which case it can sometimes be used as a cheap alternative to veneer .

6. Adhesive bonding - Wikipedia

   en.wikipedia.org/wiki/Adhesive_bonding

   Pre-treatment can be used to modify surfaces in a targeted way and thus make them more adhesive. [3] In addition to coating the substrates with an adhesion promoter to enable good adhesion, surfaces can also be modified by various methods to prepare them for gluing. The most common surface pre-treatment methods are listed in the adjacent figure.

7. Adhesive - Wikipedia

   en.wikipedia.org/wiki/Adhesive

   The glue gun melts the solid adhesive, then allows the liquid to pass through its barrel onto the material, where it solidifies. Thermoplastic glue may have been invented around 1940 by Procter & Gamble as a solution to the problem that water-based adhesives, commonly used in packaging at that time, failed in humid climates, causing packages to ...

8. Hot-melt adhesive - Wikipedia

   en.wikipedia.org/wiki/Hot-melt_adhesive

   The glue squeezed out of the heated nozzle is initially hot enough to burn and even blister skin. The glue is sticky when hot, and solidifies in a few seconds to one minute. Hot-melt adhesives can also be applied by dipping or spraying, and are popular with hobbyists and crafters both for affixing and as an inexpensive alternative to resin casting.

9. Polyvinyl acetate - Wikipedia

   en.wikipedia.org/wiki/Polyvinyl_acetate

   As wood glue, PVAc is known as "white glue" and the yellow as "carpenter's glue". As paper adhesive during paper packaging conversion. In bookbinding and book arts, due to its flexible strong bond and non- acidic nature (unlike many other polymers).