Search results
Results from the WOW.Com Content Network
The fuel consumption is an equivalent measure for cars sold outside the United States, typically measured in litres per 100 km traveled; in general, the fuel consumption and miles per gallon would be reciprocals with appropriate conversion factors, but because different countries use different driving cycles to measure fuel consumption, fuel ...
When oil is produced to surface temperature and pressure it is usual for some natural gas to come out of solution. The gas/oil ratio (GOR) is the ratio of the volume of gas ("scf") that comes out of solution to the volume of oil — at standard conditions. In reservoir simulation gas/oil ratio is usually abbreviated .
Oil conversion factor from m³ to bbl (or stb) is 6.28981100 Gas conversion factor from standard m³ to scf is 35.314666721 Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
For particulate removal, the liquid-to-gas ratio is a function of the mechanical design of the system; while for gas absorption this ratio gives an indication of the difficulty of removing a pollutant. Most wet scrubbers used for particulate control operate with liquid-to-gas ratios in the range of 4 to 20 gallons per 1,000 actual cubic foot (0 ...
Metric regions commonly use the tonne of oil equivalent (toe), or more often million toe (Mtoe). Since this is a measurement of mass, any conversion to barrels of oil equivalent depends on the density of the oil in question, as well as the energy content. Typically 1 tonne of oil has a volume of 1.08 to 1.19 cubic metres (6.8 to 7.5 bbl).
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
The table below includes entries for popular substances already used for their energy, or being discussed for such use. The second column shows specific energy, the energy content in megajoules per unit of mass in kilograms, useful in understanding the energy that can be extracted from the fuel.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.