Search results
Results from the WOW.Com Content Network
The result of this was that the interest of the JDŽ in the V 200 was awakened, and in 1956 ordered three locomotives; however, on Yugoslav railways the axle load limit was 16 t; [1] so Krauss-Maffei designed the ML 2200 C'C', a six axle version of the V 200 with correspondingly lower axle loads. [note 1] This was the version that the JDŽ ...
Replace old tools or get new ones with this Harbor Freight coupon for 20% off any one item. Expires Feb. 19, 2011. Valid in store, online, or over the phone. Use coupon code 74990607 online or ...
A tandem axle is defined as two or more consecutive axles whose centers are spaced more than 40 inches (102 cm) but not more than 96 inches (244 cm) apart. [10] Axles spaced less than 40 inches (102 cm) apart are considered a single axle. [11] In effect, the formula reduces the legal weight limit for shorter trucks with fewer axles (see table below
The AAR wheel arrangement system is a method of classifying locomotive (or unit) wheel arrangements that was developed by the Association of American Railroads.Essentially a simplification of the European UIC classification, it is widely used in North America to describe diesel and electric locomotives (including third-rail electric locomotives).
The Marmon-Herrington Company, Inc. is an American manufacturer of axles and transfer cases for trucks and other vehicles. [1] Earlier, the company built military vehicles and some tanks during World War II, and until the late 1950s or early 1960s was a manufacturer of trucks and trolley buses.
The axle load of a wheeled vehicle is the total weight bearing on the roadway for all wheels connected to a given axle.Axle load is an important design consideration in the engineering of roadways and railways, as both are designed to tolerate a maximum weight-per-axle (axle load); exceeding the maximum rated axle load will cause damage to the roadway or railway tracks.
1909 A.S.L. motorcycle with air suspension. On 7 January 1901 the British engineer Archibald Sharp patented a method for making a seal allowing pneumatic or hydraulic apparatus described as a "rolling mitten seal", [1] and on 11 January 1901 he applied for a patent for the use of the device to provide air suspension on bicycles. [2]
The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...