Search results
Results from the WOW.Com Content Network
One of the reasons for creating sections of 640 acres (260 ha) was the ease of dividing into halves and quarters while still maintaining a whole number of acres. A section can be halved seven times in this way, down to a 5-acre (2 ha) parcel, or half of a quarter-quarter-quarter section—an easily surveyed 50-square-chain (2 ha) area. This ...
One acre equals 1 ⁄ 640 (0.0015625) square mile, 4,840 square yards, 43,560 square feet, [2] or about 4,047 square metres (0.4047 hectares) (see below).While all modern variants of the acre contain 4,840 square yards, there are alternative definitions of a yard, so the exact size of an acre depends upon the particular yard on which it is based.
In the original Homestead Act of 1862, during the Lincoln administration, each settler was allocated 160 acres (0.65 km 2) of land, a quarter-section. Later amendments of the Homestead Act allocated more land, as much as 640 acres (2.6 km 2), a section. This was a good revision to apply to land that was drier or more desolate than the earlier ...
A lot has defined boundaries (or borders) which are documented somewhere, but the boundaries need not be shown on the land itself. Most lots are small enough to be mapped as if they are flat, in spite of the curvature of the Earth. A characteristic of the size of a lot is its area. The area is typically determined as if the land is flat and ...
As the name suggests, an acre-foot is defined as the volume of one acre of surface area to a depth of one foot.. Since an acre is defined as a chain by a furlong (i.e. 66 ft × 660 ft or 20.12 m × 201.17 m), an acre-foot is 43,560 cubic feet (1,233.5 m 3).
Since an acre measured 10 square chains in Gunter's system, the entire process of land area measurement could be computed using measurements in chains, and then converted to acres by dividing the results by 10. [2] Hence 10 chains by 10 chains (100 square chains) equals 10 acres, 5 chains by 5 chains (25 square chains) equals 2.5 acres.
The lot and block survey system is a method used in the United States and Canada to locate and identify land, particularly for lots in densely populated metropolitan areas, suburban areas and exurbs. It is sometimes referred to as the recorded plat survey system or the recorded map survey system .
In Arkansas and Missouri, the official conversion is 1 arpent = 0.8507 acres (3,443 square metres). [3] In Paris, the square arpent was 220 French feet × 220 French feet = 48,400 French square feet, about 5,107 square metres or 1.262 acres. In Mauritius and Seychelles, an arpent is about 4220.87 square metres, 0.4221 hectares, 1.043 acres. [4]