Search results
Results from the WOW.Com Content Network
The chkdsk command on Windows XP. CHKDSK can be run from DOS prompt, Windows Explorer, Windows Command Prompt, Windows PowerShell or Recovery Console. [10] On Windows NT operating systems, CHKDSK can also check the disk surface for bad sectors and mark them (in MS-DOS 6.x and Windows 9x, this is a task done by Microsoft ScanDisk).
However, certain tools can be used to modify the HPA or DCO. The system uses the IDENTIFY_DEVICE command to determine the supported features of a given hard drive, but the DCO can report to this command that supported features are nonexistent or that the drive is smaller than it actually is.
The name derives from IBM's habit of calling hard drives fixed disks. FDISK has the ability to display information about, create, and delete DOS partitions or logical DOS drive. It can also install a standard master boot record on the hard drive. The command is available in MS-DOS versions 3.2 and later and IBM PC DOS 2.0 releases and later. [1]
hdparm is a command line program for Linux to set and view ATA hard disk drive hardware parameters and test performance. [2] [3] It can set parameters such as drive caches, sleep mode, power management, acoustic management, and DMA settings. GParted [citation needed] and Parted Magic both include hdparm. [4]
In 2008, Hard Disk Sentinel DOS version was released in different formats on bootable pen drive, CD, floppy. Usable when no operating system installed (or if the system is not bootable otherwise) to detect and display temperature, health status of IDE, SATA hard disk drives and with limited AHCI controller support.
Windows File Recovery is a command-line software utility from Microsoft to recover deleted files. [1] [2] It is freely available for Windows 10 version 2004 (May 2020 Update) and later from the Microsoft Store. [3] Windows File Recovery can recover files from a local hard disk drive (HDD), USB flash drive, or memory card such as an SD card.
The recovery console is used to provide a way to access the hard drive in an emergency through the command prompt. The Recovery Console can be started from Windows 2000 / XP / 2003 Setup CD. The Recovery Console can be accessed in two ways, either through the original installation media used to install Windows, or by installing it onto the hard ...
Drive: This command-line argument specifies the drive letter of the disk for which to display the volume label and serial number. Note: On Windows, the volume serial number is displayed only for disks formatted with MS-DOS version 4.0 or later. OS/2 allows the user to specify more than one drive. The vol command displays the volume labels ...