Search results
Results from the WOW.Com Content Network
A 50 m × 25 m (164 ft × 82 ft) Olympic swimming pool, built to the FR3 minimum depth of 2 metres (6.6 ft) would hold 2,500 m 3 (660,000 US gal). The US National Institute of Standards and Technology (NIST) defines the Olympic swimming pool as 1 million litres, which is the approximate volume of the smaller FR2 pool.
The 1000-foot reels held 4096 blocks of 64 words per block (4096 x 64 x 39 = 10,223,616 bits, or the equivalent of about 1.3 megabytes). Another unusual feature is the use of magnetic cores not only for memory but also as logic gates. These logic cores have 1, 2 or 3 input windings, a trigger (read) and an output winding.
If the sides of a rectangle are measured as 1.23 m and 4.56 m, then multiplication gives an area for the rectangle between 5.614591 m 2 and 5.603011 m 2. Since not even the second digit after the decimal place is preserved, the following digits are not significant. Therefore, the result is usually rounded to 5.61.
The CLEO I drift chamber (DR) was immediately outside the IZ and occupied the region between a radius of 17.3 cm and 95 cm. It consisted of seventeen layers of 11.3 mm × 10.0 mm cells with 42.5 mm between the layers, for a total of 5304 cells. There were two layers of field wires for every layer of sense wires.
[5] [6] For example, excess combustion air of 15 percent means that 15 percent more than the required stoichiometric air (or 115 percent of stoichiometric air) is being used. A combustion control point can be defined by specifying the percent excess air (or oxygen) in the oxidant, or by specifying the percent oxygen in the combustion product. [7]
[14] [15] Early detection through screening is useful for cervical and colorectal cancer. [16] The benefits of screening for breast cancer are controversial. [16] [17] Cancer is often treated with some combination of radiation therapy, surgery, chemotherapy and targeted therapy. [2] [4] Pain and symptom management are an important part of care. [2]
Iron powder is commonly used for sintering. Powder metallurgy (PM) is a term covering a wide range of ways in which materials or components are made from metal powders.PM processes are sometimes used to reduce or eliminate the need for subtractive processes in manufacturing, lowering material losses and reducing the cost of the final product. [1]