Search results
Results from the WOW.Com Content Network
For example, 26 cannot be divided by 11 to give an integer. Such a case uses one of five approaches: Say that 26 cannot be divided by 11; division becomes a partial function. Give an approximate answer as a floating-point number. This is the approach usually taken in numerical computation.
In general, if an increase of x percent is followed by a decrease of x percent, and the initial amount was p, the final amount is p (1 + 0.01 x)(1 − 0.01 x) = p (1 − (0.01 x) 2); hence the net change is an overall decrease by x percent of x percent (the square of the original percent change when expressed as a decimal number).
Spread spectrum makes it possible to have as low a frequency reuse factor as 1, if each base station is divided into 3 cells by means of 3 directional sector antennas. This corresponds to a system spectrum efficiency of over 1 × 100 × 0.0017 = 0.17 (bit/s)/Hz per site , and 0.17/3 = 0.06 (bit/s)/Hz per cell or sector .
All of the significant digits remain, but the placeholding zeroes are no longer required. Thus 1 230 400 would become 1.2304 × 10 6 if it had five significant digits. If the number were known to six or seven significant figures, it would be shown as 1.230 40 × 10 6 or 1.230 400 × 10 6. Thus, an additional advantage of scientific notation is ...
In statistical quality control, the individual/moving-range chart is a type of control chart used to monitor variables data from a business or industrial process for which it is impractical to use rational subgroups. [1] The chart is necessary in the following situations: [2]: 231
If the mass of an object is estimated as 3.78 ± 0.07 kg, so the actual mass is probably somewhere in the range 3.71 to 3.85 kg, and it is desired to report it with a single number, then 3.8 kg is the best number to report since its implied uncertainty ± 0.05 kg gives a mass range of 3.75 to 3.85 kg, which is close to the measurement range.
The chart was designed by Ian Bailey [5] and Jan E. Lovie-Kitchin at the National Vision Research Institute of Australia. [1] [3] They described their motivation for designing the LogMAR chart as follows: "We have designed a series of near vision charts in which the typeface, size progression, size range, number of words per row and spacings were chosen in an endeavour to achieve a ...
The table shown on the right can be used in a two-sample t-test to estimate the sample sizes of an experimental group and a control group that are of equal size, that is, the total number of individuals in the trial is twice that of the number given, and the desired significance level is 0.05. [4]