Search results
Results from the WOW.Com Content Network
For instance, to safely fill a new container or a pressure vessel with flammable gases, the atmosphere of normal air (containing 20.9 volume percent of oxygen) in the vessel would first be flushed (purged) with nitrogen or another non-flammable inert gas, thereby reducing the oxygen concentration inside the container. When the oxygen ...
Highly Toxic: a gas that has a LC 50 in air of 200 ppm or less. [2] NFPA 704: Materials that, under emergency conditions, can cause serious or permanent injury are given a Health Hazard rating of 3. Their acute inhalation toxicity corresponds to those vapors or gases having LC 50 values greater than 1,000 ppm but less than or equal to 3,000 ppm ...
This is a list of Superfund sites in Pennsylvania designated under the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) environmental law.The CERCLA federal law of 1980 authorized the United States Environmental Protection Agency (EPA) to create a list of polluted locations requiring a long-term response to clean up hazardous material contaminations. [1]
December 13, 2016 – Fire at a natural gas compressor station, located outside the village of Wharton Township, Potter County, Pennsylvania. [146] December 25, 2016 – A fire broke out at a gas compressor station, in Armstrong County. [147] January 1, 2017 – Fire erupts at Marcellus Shale pad in Somerset Township, Washington County. [148]
An aerosol must be assigned to Division 2.1 if it is deemed flammable in accordance with the appropriate tests of the UN Manual of Tests and Criteria for flammability. Division 2.2: Non-Flammable, Non-Toxic Gas This division includes compressed gas, liquefied gas, pressurized cryogenic gas, compressed gas in solution, asphyxiant gas and ...
Consider the first triangular diagram below, which shows all possible mixtures of methane, oxygen and nitrogen. Air is a mixture of about 21 volume percent oxygen, and 79 volume percent inerts (nitrogen). Any mixture of methane and air will therefore lie on the straight line between pure methane and pure air – this is shown as the blue air-line.
The system can be flushed with an inert gas to reduce the concentration of oxygen so that when the flammable gas is admitted, an ignitable mixture cannot form. In NFPA 56, [1] this is known as purge-into-service. In combustion engineering terms, the admission of inert gas dilutes the oxygen below the limiting oxygen concentration.
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas, and flame arrestor devices. [1]