enow.com Web Search

  1. Ads

    related to: 1 7/8 deep well socket 1 2 drive to 3 8 drive adapter

Search results

  1. Results from the WOW.Com Content Network
  2. Socket wrench - Wikipedia

    en.wikipedia.org/wiki/Socket_wrench

    These drive fittings come in four common sizes: 1 ⁄ 4 inch, 38 inch, 12 inch, and 3 ⁄ 4 inch (referred to as "drives", as in "38 drive"). Despite being denominated in inches, these are trade names ( common product name ), and manufacturers construct them to 6.3 mm, 9.5 mm, 12.5 mm and 19 mm, having been rounded to a ...

  3. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    2.4: 0–1 18: 3.2: 2 5 ... The spline socket drive system was patented in the United States in 1913 ... The wall adapter has a molded screwdriver on its case to ...

  4. Deepwater well integrity - Wikipedia

    en.wikipedia.org/wiki/Deepwater_well_integrity

    By detecting the two important indicators of temperature and pressure, the change in borehole thickness of the casing string, as well as the location of leakage points and types of damage, can be determined. [7] Therefore a comprehensive assessment of deepwater wellbore integrity can be conducted.

  5. Slotket - Wikipedia

    en.wikipedia.org/wiki/Slotket

    Socket 8 slocket adapter Socket 370 slotket adapter. In computer hardware terminology, slotkets, also known as slockets, (both short for slot to socket adapter) are adapters that allow socket-based microprocessors to be used on slot-based motherboards. Slotkets were first created to allow the use of Socket 8 Pentium Pro processors on Slot 1 ...

  6. Phone connector (audio) - Wikipedia

    en.wikipedia.org/wiki/Phone_connector_(audio)

    The outside diameter of the sleeve is 6.35 millimetres (1 ⁄ 4 inch) for full-sized connectors, 3.5 mm (18 in) for "mini" connectors, and only 2.5 mm (1 ⁄ 10 in) for "sub-mini" connectors. Rings are typically the same diameter as the sleeve.

  7. Well control - Wikipedia

    en.wikipedia.org/wiki/Well_control

    Consider two wells, X and Y. Well X has a measured depth of 9,800 ft and a true vertical depth of 9,800 ft while well Y has measured depth of 10,380 ft while its true vertical depth is 9,800 ft. To calculate the hydrostatic pressure of the bottom hole, the true vertical depth is used because gravity acts (pulls) vertically down the hole. [2]

  1. Ads

    related to: 1 7/8 deep well socket 1 2 drive to 3 8 drive adapter