Search results
Results from the WOW.Com Content Network
A fiber-optic current sensor (FOCS) is a device designed to measure direct current. Utilizing a single-ended optical fiber wrapped around the current conductor, [1] FOCS exploits the magneto-optic effect (Faraday effect). [2] The FOCS can measure uni- or bi-directional DC currents up to 600 kA, with an accuracy within ±0.1% of the measured value.
A fiber-optic AC/DC voltage sensor in the middle and high voltage range (100–2000 V) can be created by inducing measurable amounts of Kerr nonlinearity in single-mode optical fiber by exposing a calculated length of fiber to the external electric field. [15]
A fiber media converter is a simple networking device that makes it possible to connect two dissimilar media types such as twisted pair with fiber optic cabling. They were introduced to the industry in the 1990s, and are important in interconnecting fiber optic cabling-based systems with existing copper-based structured cabling systems.
On October 23, 2008, AT&T announced the completion of upgrades to OC-768 on 80,000 fiber-optic wavelength miles of their IP/MPLS backbone network. [6] OC-768 SONET interfaces have been available with short-reach optical interfaces from Cisco since 2006.
The optical pulse is attenuated as it propagates along the fiber. For a single mode fiber operating at 1550 nm, a typical attenuation is 0.2 dB/km. [1] Since the light must make a double pass along each section of fiber, this means each 1 km causes a total loss of 0.4 dB. The maximum range of the system occurs when the amplitude of the ...
ARINC 818 (Avionics Digital Video Bus) is a point-to-point, 8b/10b-encoded (or 64B/66B for higher speeds) serial protocol for transmission of video, audio, and data. The protocol is packetized but is video-centric and very flexible, supporting an array of complex video functions including the multiplexing of multiple video streams on a single link or the transmission of a single stream over a ...
So they are largely used for single-mode fiber testing at 1270 - 1650 nm. An important part of an optical power meter sensor, is the fiber optic connector interface. Careful optical design is required to avoid significant accuracy problems when used with the wide variety of fiber types and connectors typically encountered.
Fiber optic current sensor, using an interferometer to measure the phase change in the light produced by a magnetic field. Rogowski coil, electrical device for measuring alternating current (AC) or high speed current pulses. Giant Magnetoresistance(GMR): Magnetic field sensor suitable for AC & DC Current with higher accuracy than Hall Effect ...