Search results
Results from the WOW.Com Content Network
A turbo-compound engine is a reciprocating engine that employs a turbine to recover energy from the exhaust gases. Instead of using that energy to drive a turbocharger as found in many high-power aircraft engines , the energy is instead sent to the output shaft to increase the total power delivered by the engine.
Ray-traced image of a piston engine. There may be one or more pistons. Each piston is inside a cylinder, into which a gas is introduced, either already under pressure (e.g. steam engine), or heated inside the cylinder either by ignition of a fuel air mixture (internal combustion engine) or by contact with a hot heat exchanger in the cylinder (Stirling engine).
Steam powers two types of engine, reciprocating (with steam driving pistons connected to a crankshaft) and turbine (with steam driving blades attached radially to a spinning shaft). The shaft power from each can either go directly to the propeller, pump jet or other mechanism, or it goes through some form of transmission; mechanical, electrical ...
Steam engines and turbines operate on the Rankine cycle which has a maximum Carnot efficiency of 63% for practical engines, with steam turbine power plants able to achieve efficiency in the mid 40% range. The efficiency of steam engines is primarily related to the steam temperature and pressure and the number of stages or expansions. [15]
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
[citation needed] [1] For example, inside an internal combustion engine (a type of reciprocating engine), the expansion of burning fuel in the cylinders periodically pushes the piston down, which, through the connecting rod, turns the crankshaft. The continuing rotation of the crankshaft drives the piston back up, ready for the next cycle.
1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...
Period cutaway diagram of a triple-expansion steam engine installation, circa 1918. This particular diagram illustrates possible engine cutoff locations, after the Lusitania disaster and others made it clear that this was an important safety feature. A marine steam engine is a steam engine that is used to power a ship or boat.