Search results
Results from the WOW.Com Content Network
A turbo-compound engine is a reciprocating engine that employs a turbine to recover energy from the exhaust gases. Instead of using that energy to drive a turbocharger as found in many high-power aircraft engines , the energy is instead sent to the output shaft to increase the total power delivered by the engine.
Ray-traced image of a piston engine. There may be one or more pistons. Each piston is inside a cylinder, into which a gas is introduced, either already under pressure (e.g. steam engine), or heated inside the cylinder either by ignition of a fuel air mixture (internal combustion engine) or by contact with a hot heat exchanger in the cylinder (Stirling engine).
Double-acting stationary steam engine demonstrating conversion of reciprocating motion to rotary motion. The piston is on the left, and the crank is mounted on the flywheel axle on the right Machine demonstrating the conversion of rotary motion to reciprocating motion using gears. The bottom pair of gears drives the mechanism
1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...
Steam powers two types of engine, reciprocating (with steam driving pistons connected to a crankshaft) and turbine (with steam driving blades attached radially to a spinning shaft). The shaft power from each can either go directly to the propeller, pump jet or other mechanism, or it goes through some form of transmission; mechanical, electrical ...
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
A reciprocating imbalance is caused when the linear motion of a component (such as a piston) is not cancelled out by another component moving with equal momentum, but opposite in direction on the same plane. Types of reciprocating phase imbalance are: Mismatch in counter-moving pistons, such as in a single-cylinder engine or an inline-three engine.
The reciprocating motion of a non-offset piston connected to a rotating crank through a connecting rod (as would be found in internal combustion engines) can be expressed by equations of motion. This article shows how these equations of motion can be derived using calculus as functions of angle (angle domain) and of time (time domain).