Search results
Results from the WOW.Com Content Network
In an internal combustion engine, the engine block is the structure that contains the cylinders and other components. The engine block in an early automotive engine consisted of just the cylinder block, to which a separate crankcase was attached. Modern engine blocks typically have the crankcase integrated with the cylinder block as a single ...
It is widely accepted [citation needed] however that the minimum requirement for a vehicle to be Number matching (or matching numbers, depending on local terminology) is for the original Chassis number and/or Vehicle Identification Number (VIN) to match to the engine block, if that is how the original manufacturer identified it, and the data ...
The early engines' bell pattern differed from AMC V8s. In 1971 AMC raised the block height and lengthened the stroke on the 199 and early 232 engines. The 199 became 232 cubic inches and the 232 became 258. These two RB or "raised block" engines shared the small bell pattern of the earlier engines for only the 1971 model year.
All engines in this family share the same block dimensions and sometimes even the same casting number; the latter meaning engines were of the same block, but with different strokes (e.g., the casting number 3970010 was used by all three engines: 302, 327, and 350).
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
The Ford Cologne V6 is a series of 60° cast iron block V6 engines produced by the Ford Motor Company from 1962 to 2011 in displacements between 1.8 L; 110.6 cu in (1,812 cc) and 4.0 L; 244.6 cu in (4,009 cc).
The Oldsmobile engine block formed the basis of the Repco 3-liter engine used by Brabham to win the 1966 and 1967 Formula One world championships. The early Repco engines produced up to 300 bhp (220 kW), and featured new SOHC cylinder heads and iron cylinder liners. The 1967 and later versions of the Repco engine had proprietary engine blocks.
The numeric engine referencing system used until the mid-1980s was simply the chronological sequence of engine development projects. Thus, variants based on the same engine block may have unrelated numbers.