enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Flat-blade jeweler's screwdrivers and the tips found in 1 ⁄ 4-inch or 6.4-millimeter drive sets are generally hollow-ground. Note that it is this typical chisel shape which allows 9 screwdriver sizes to drive 24 different slotted screw sizes, with the drawbacks of not fitting as closely as a hollow-ground screwdriver would, and increasing the ...

3. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   A screwdriver is classified by its tip, which is shaped to fit the driving surfaces (slots, grooves, recesses, etc.) on the corresponding screw head. Proper use requires that the screwdriver's tip engage the head of a screw of the same size and type designation as the screwdriver tip. Screwdriver tips are available in a wide variety of types ...

4. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

5. Remove Stubborn Nuts and Bolts With These Editor-Approved ...

   www.aol.com/lifestyle/best-adjustable-wrenches...

   For premium support please call: 800-290-4726 more ways to reach us

6. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   Normally, 3 different slot type tips were included with each screwdriver when it was new. [3] Other tips included: Nut drivers in various sizes, both hex and square head; Drill points for the smallest 133/135 size screwdriver; adapters to adapt push drill size drill point sets to the three sizes of screwdriver chuck size; countersinks ...

7. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Screwdriver bits in different sizes for Robertson screws. When Henry Ford tried the Robertson screws, he found that they saved considerable time in Model T production. When Robertson refused to license the design, Ford realized that the supply of screws would not be guaranteed, and chose to limit their use to his Canadian division. [4] [5] [6]