enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of components of oil drilling rigs - Wikipedia

   en.wikipedia.org/wiki/List_of_components_of_oil...

   Drill bit (#26) is a device attached to the end of the drill string that breaks apart the rock being drilled. It contains jets through which the drilling fluid exits. Drill floor (#21) is the area on the rig where the tools are located to make the connections of the drill pipe, bottom hole assembly, tools and bit. It is considered the main area ...

3. Swivel (drill rig) - Wikipedia

   en.wikipedia.org/wiki/Swivel_(drill_rig)

   A Swivel is a mechanical device used on a drilling rig that hangs directly under the traveling block and directly above the kelly drive, that provides the ability for the kelly (and subsequently the drill string) to rotate while allowing the traveling block to remain in a stationary rotational position (yet allow vertical movement up and down the derrick) while simultaneously allowing the ...

4. Bottom hole assembly - Wikipedia

   en.wikipedia.org/wiki/Bottom_hole_assembly

   Rotary assemblies [2] are commonly used where formations are predictable and the rig economics are an issue. In such an assembly the weight of the drill collars gives the BHA the tendency to sag or flex to the low side of the hole, collar stiffness length and stabiliser diameter and placement are engineered as a means of controlling the flex of the BHA.

5. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The R8 system is commonly used with collets ranging in size from 1 ⁄ 8 ″ to 3 ⁄ 4 ″ in diameter or tool holders with the same or slightly larger diameters. The collets or tool holders are placed directly into the spindle and the drawbar is tightened into the top of the collet or tool holder from above the spindle.

6. Lincoln Electric - Wikipedia

   en.wikipedia.org/wiki/Lincoln_Electric

   The company was founded in 1895 by John C. Lincoln with an investment of $200 to make electric motors he had designed. [3]The company is headquartered in Euclid, Ohio, and has 44 manufacturing locations, including operations and joint ventures in 19 countries and an international network of distributors and sales offices covering more than 160 countries.

7. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Large drill bits can have straight shanks narrower than the drill diameter so that they can be fitted in chucks not able to chuck the full diameter. Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2-inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8-inch (9.5 mm) chuck.