Ad
related to: chamfer vs fillet
Search results
Results from the WOW.Com Content Network
In mechanical engineering, a fillet (pronounced / ˈ f ɪ l ɪ t /, like "fill it") is a rounding of an interior or exterior corner of a part. An interior or exterior corner, with an angle or type of bevel , is called a " chamfer ".
A chamfer may sometimes be regarded as a type of bevel, and the terms are often used interchangeably. In furniture-making, a lark's tongue is a chamfer which ends short of a piece in a gradual outward curve, leaving the remainder of the edge as a right angle. Chamfers may be formed in either inside or outside adjoining faces of an object or room.
Chamfer, a transitional straight edge between two faces of an object; Fillet, a rounding of an interior or exterior corner between two faces of an object; Draft, the amount of taper for molded or cast parts perpendicular to the parting line
Side views of a bevel (above) and a chamfer (below). A bevelled edge (UK) or beveled edge (US) is an edge of a structure that is not perpendicular to the faces of the piece. . The words bevel and chamfer overlap in usage; in general usage, they are often interchanged, while in technical usage, they may be differentiated as shown in the image on the ri
The second sentece says that a fillet is the opposite of a chamfer, implying that something that fills in an interior angle is *not* a chamfer. --—Preceding unsigned comment added by 72.17.139.211 (talk • contribs) It is my opinion that the real difference between a "fillet" and a "chamfer" is that a fillet is curved, while a chamfer is ...
The chamfered cube is constructed as a chamfer of a cube: the squares are reduced in size and new faces, hexagons, are added in place of all the original edges. The cC is a convex polyhedron with 32 vertices, 48 edges, and 18 faces: 6 congruent (and regular) squares, and 12 congruent flattened hexagons.
Form diameter is the diameter of a circle at which the trochoid (fillet curve) produced by the tooling intersects, or joins, the involute or specified profile. Although these terms are not preferred, it is also known as the true involute form diameter (TIF), start of involute diameter (SOI), or when undercut exists, as the undercut diameter.
Parts of a fillet weld. There are 5 pieces to each fillet weld known as the root, toe, face, leg and throat. [2] The root of the weld is the part of deepest penetration which is the opposite angle of the hypotenuse. The toes of the weld are essentially the edges or the points of the hypotenuse.
Ad
related to: chamfer vs fillet