enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   An insulation-displacement contact (IDC), also known as insulation-piercing contact (IPC), is an electrical connector designed to be connected to the conductor(s) of an insulated cable by a connection process which forces a selectively sharpened blade or blades through the insulation, bypassing the need to strip the conductors of insulation ...

3. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available. In some cases the blade is an integral manufactured part of a component (such as a switch or a speaker unit), and the reciprocal connector terminal is pushed onto the device's connector ...

4. Electric wire ferrule - Wikipedia

   en.wikipedia.org/wiki/Electric_wire_ferrule

   Top: wire terminating in an insulated ferrule Center: Several ferrules with colored insulation, and two uninsulated ferrules Insulated, and uninsulated ferrules. An electric wire ferrule (sometimes electric end terminal) is a metal tube crimped over stranded wire to secure the strands within a screw terminal. Electrical insulation may be ...

5. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   PLASTI-GRIP (Vinyl) (insulation restricting) terminals are defined in AMP Specification 114-1003: Terminal, FASTON, PLASTI-GRIP, Application of; UL 310 "Standard for Electrical Quick-Connect Terminals" [3] CSA 22.2 #153, "Quick-Connect Terminals" UL 486 also specifies the testing of standard wire connectors and soldering lugs. MIL-T-7928

6. 110 block - Wikipedia

   en.wikipedia.org/wiki/110_block

   A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

7. Screw terminal - Wikipedia

   en.wikipedia.org/wiki/Screw_terminal

   Screw terminals, as individual connectors to a board at left, as a barrier strip with setscrews at top, and as a barrier strip with attached spade and loop lugs at bottom. A screw terminal is a type of electrical connection where a wire is held by the tightening of a screw.