enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Over 140,000 trailer hitch locks recalled for risk of ... - AOL

   www.aol.com/over-140-000-trailer-hitch-224708772...

   More than 140,000 trailer hitch locks are being recalled due to a loose part that could cause towing vehicles to detach from their loads. Horizon Global is recalling certain Reese hitch receiver ...

3. Tow hitch - Wikipedia

   en.wikipedia.org/wiki/Tow_hitch

   The trailer hitch ball attaches to a ball mount; with a diameter typically 1 ⁄ 16 inch (1.6 mm) larger than the ball bolt/shank diameter. [2] The ball mount must match the SAE hitch class. [3] The ballmount for a receiver-type hitch is a square bar that fits into a receiver attached to the vehicle.

4. Fifth-wheel coupling - Wikipedia

   en.wikipedia.org/wiki/Fifth-wheel_coupling

   Modern fifth wheels allow the trailers to slide into the fifth wheel and lock into it very reliably when maintained and serviced properly. The engagement of the king pin into the fifth-wheel locking mechanism is the only means of connection between tractor and trailer; no other device or safety mechanism is used.

5. End-of-train device - Wikipedia

   en.wikipedia.org/wiki/End-of-train_device

   An ETD on a container train in 2005. The end of train device (ETD), sometimes referred to as an EOT, flashing rear-end device (FRED) or sense and braking unit (SBU) is an electronic device mounted on the end of freight trains in replacement of a caboose.

6. Buffers and chain coupler - Wikipedia

   en.wikipedia.org/wiki/Buffers_and_chain_coupler

   Narrow gauge flat wagons, 750 mm (2 ft 5 + 1 ⁄ 2 in).Note the single buffer with a hook on the right side and a chain on the other. On some narrow-gauge lines in Europe, and on the Paris Metro, a simplified version of the loose-coupler is used, consisting of a single central buffer with a chain underneath.

7. Twistlock - Wikipedia

   en.wikipedia.org/wiki/Twistlock

   The female part of the connector is the 7×7× 4 + 1 ⁄ 2 in (180×180×110 mm) corner casting, which forms each of the eight corners, welded to the container itself, and has no moving parts, only an oval hole in the tops of the four upper corners, and in the bottom of the four lower corners.