enow.com Web Search

  1. Ads

    related to: how to make analog tv antenna

Search results

  1. Results from the WOW.Com Content Network
  2. Analog television - Wikipedia

    en.wikipedia.org/wiki/Analog_television

    Analog television is the original television technology that uses analog signals to transmit video and audio. [1] In an analog television broadcast, the brightness, colors and sound are represented by amplitude , phase and frequency of an analog signal.

  3. Output power of an analog TV transmitter - Wikipedia

    en.wikipedia.org/wiki/Output_power_of_an_analog...

    The output power of a TV transmitter is the electric power applied to antenna system. There are two definitions: nominal (or peak) and thermal. Analogue television systems put about 70% to 90% of the transmitters power into the sync pulses. The remainder of the transmitter's power goes into transmitting the video's higher frequencies and the FM ...

  4. Television antenna - Wikipedia

    en.wikipedia.org/wiki/Television_antenna

    Outdoor antennas provide up to a 15 dB gain in signal strength and 15-20 dB greater rejection of ghost signals in analog TV. [6] Combined with a signal increase of 14 dB due to height and 11 dB due to lack of attenuating building walls, an outdoor antenna can result in a signal strength increase of up to 40 dB at the TV receiver. [6]

  5. Television transmitter - Wikipedia

    en.wikipedia.org/wiki/Television_transmitter

    A television transmitter is a transmitter that is used for terrestrial (over-the-air) television broadcasting.It is an electronic device that radiates radio waves that carry a video signal representing moving images, along with a synchronized audio channel, which is received by television receivers ('televisions' or 'TVs') belonging to a public audience, which display the image on a screen.

  6. Television interference - Wikipedia

    en.wikipedia.org/wiki/Television_interference

    It is possible to also get a bad picture if the signal strength of the TV transmitter is too high. An attenuator inserted in the antenna lead-in wire may be used if the television receiver displays signs of overload in the RF front end. Strong out-of-band signals may also affect television reception and may require band-pass filters to reduce ...

  7. ATSC tuner - Wikipedia

    en.wikipedia.org/wiki/ATSC_tuner

    Canada had a similar analog TV termination date set to September 1, 2011 (except in some remote northern regions). [citation needed] It was feared that the US switch-off would cause millions of non-cable- and non-satellite-connected TV sets to "go dark". Viewers who did not upgrade, either to a television with a digital tuner or a set-top box ...

  1. Ads

    related to: how to make analog tv antenna