enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Imperial Metric fastening size conversion charts; International Thread Standards; Conversion chart Whitworth/BSF/AF and metric Archived 2 May 2010 at the Wayback Machine; Spanner Jaw Sizes Additional information and spanner jaw size table. Unified Screw Threads Series; ASME B1.1-2003 Unified Inch Screw Threads, (UN and UNR Thread Form)

3. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

4. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   To simplify matters, the term hexagon is used in this section to denote either bolt head or nut. Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats ...

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.

6. British Association screw threads - Wikipedia

   en.wikipedia.org/wiki/British_Association_screw...

   The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts; BS 93:1951 — Specification for British Association (B.A.) screw threads with ...

7. United States Standard thread - Wikipedia

   en.wikipedia.org/wiki/United_States_Standard_thread

   United States Standard thread (USS thread), also known as Sellers Standard thread, [1] Franklin Institute thread [1] and American Standard thread, [2] is a standard for inch based threaded fasteners and washers. [3] The USS standard is no longer supported. It, together with the SAE fastener standard, was incorporated into the Unified Thread ...

8. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   Below are some common spanner sizes for metric screw threads. Hexagonal (generally abbreviated to "hex") head widths (width across flats, spanner size) are for DIN 934 hex nuts and hex head bolts. Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have ...