Search results
Results from the WOW.Com Content Network
The Rockwell hardness test can be conducted on different types of hardness testers. [12] Benchtop hardness testers can be found either in a digital or analog model. Digital models utilize a digital display whereas the analog models display results on a dial on the machine.
A variety of hardness-testing methods are available, including the Vickers, Brinell, Rockwell, Meyer and Leeb tests. Although it is impossible in many cases to give an exact conversion, it is possible to give an approximate material-specific comparison table for steels .
Meyer hardness test; Rockwell hardness test (HR), principally used in the USA. HRA, HRB and HRC scales are most widely used. [9] Shore hardness test, for polymers, widely used in the rubber industry. [10] Barcol hardness test, for composite materials. There is, in general, no simple relationship between the results of different hardness tests.
This page was last edited on 16 November 2024, at 12:16 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Here is a listing of some of the most common tests: [2] Hardness Testing. Vickers hardness test (HV), which has one of the widest scales; Brinell hardness test (HB) Knoop hardness test (HK), for measurement over small areas; Janka hardness test, for wood; Meyer hardness test; Rockwell hardness test (HR), principally used in the USA
The basic test requires applying the force in a consistent manner, without shock, and measuring the hardness (depth of the indentation). If a timed hardness is desired, force is applied for the required time and then read. The material under test should be a minimum of 6 mm (0.25 inches) thick. [3]
The governing standard for the Barcol hardness test is ASTM D 2583. [4] Barcol hardness is measured on a scale from 0 to 100 with the typical range being between 50B and 90B. A measurement of 60B is roughly equivalent to a Shore hardness of 80D or a Rockwell hardness M100.
When testing coatings, scratch hardness refers to the force necessary to cut through the film to the substrate. The most common test is Mohs scale, which is used in mineralogy. One tool to make this measurement is the sclerometer. Another tool used to make these tests is the pocket hardness tester. This tool consists of a scale arm with ...