Search results
Results from the WOW.Com Content Network
Discharge efficiency Self-discharge rate Shelf life Anode Electrolyte Cathode Cutoff Nominal ... Low self-discharge nickel–metal hydride battery: 500–1,500 [13]
Manufacturers specify the capacity of a battery at a specified discharge rate. For example, a battery might be rated at 100 A·h when discharged at a rate that will fully discharge the battery in 20 hours (at 5 amperes for this example). If discharged at a faster rate the delivered capacity is less.
While the state of charge is usually expressed using percentage points (0 % = empty; 100 % = full), depth of discharge is either expressed using units of Ah (e.g. for a 50 Ah battery, 0 Ah is full and 50 Ah is empty) or percentage points (100 % is empty and 0 % is full). The capacity of a battery may also be higher than its nominal rating.
The maximum discharge rate for a Ni–Cd battery varies by size. For a common AA-size cell, the maximum discharge rate is approximately 1.8 amperes; for a D size battery the discharge rate can be as high as 3.5 amperes.
Useful discharge capacity is a decreasing function of the discharge rate, but up to a rate of around 1×C (full discharge in 1 hour), it does not differ significantly from the nominal capacity. [26] NiMH batteries nominally operate at 1.2 V per cell, somewhat lower than conventional 1.5 V cells, but can operate many devices designed for that ...
The Headway 38120HP cells are used in high-discharge environments as they have very good continuous/peak discharge rates (10C/25C). Because four cells in series produces a voltage range similar to 6 cells of lead-acids and their fire-resistant properties, they can be used to replace a 12 V lead-acid car battery. [235] 38140: 38140s 12,000 38: 140
Nickel–zinc batteries have a charge–discharge curve similar to 1.2 V NiCd or NiMH cells, but with a higher 1.6 V nominal voltage. [5]Nickel–zinc batteries perform well in high-drain applications, and may have the potential to replace lead–acid batteries because of their higher energy-to-mass ratio and higher power-to-mass ratio – as little as 25% of the mass for the same power. [6]
The C rate is that which would theoretically fully charge or discharge the battery in one hour. For example, trickle charging might be performed at C/20 (or a "20-hour" rate), while typical charging and discharging may occur at C/2 (two hours for full capacity). The available capacity of electrochemical cells varies depending on the discharge rate.