enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wheel hub assembly - Wikipedia

   en.wikipedia.org/wiki/Wheel_hub_assembly

   The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.

3. Kingpin (automotive part) - Wikipedia

   en.wikipedia.org/wiki/Kingpin_(automotive_part)

   The kingpins were now fixed to the axle ends and the hub carriers pivoted upon them. Most commonly the centre of the kingpin was fixed in the axle and the hub carrier was forked to fit over this, but some vehicles, including the Ford Model T illustrated, used a forked axle and a kingpin fixed into a single piece carrier.

4. Portal axle - Wikipedia

   en.wikipedia.org/wiki/Portal_axle

   Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]

5. Magnetic bearing - Wikipedia

   en.wikipedia.org/wiki/Magnetic_bearing

   A magnetic bearing. A magnetic bearing is a type of bearing that supports a load using magnetic levitation. Magnetic bearings support moving parts without physical contact. For instance, they are able to levitate a rotating shaft and permit relative motion with very low friction and no mechanical wear. Magnetic bearings support the highest ...

6. Locking hubs - Wikipedia

   en.wikipedia.org/wiki/Locking_hubs

   Mechanically activated locking hubs are activated by hand by turning a switch on the end of the axle. The advantage to mechanical hubs is that they are often considered more robust, and less prone to issues due to maintenance negligence. The disadvantage of this is that the driver needs to get out of the vehicle to activate the hubs.

7. Tapered roller bearing - Wikipedia

   en.wikipedia.org/wiki/Tapered_roller_bearing

   In many applications tapered roller bearings are used in back-to-back pairs so that axial forces can be supported equally in either direction. Pairs of tapered roller bearings are used in car and vehicle wheel bearings where they must cope simultaneously with large vertical (radial) and horizontal (axial) forces.