Ad
related to: real life examples of drip irrigation methods in engineering
Search results
Results from the WOW.Com Content Network
Drip irrigation or trickle irrigation is a type of micro-irrigation system that has the potential to save water and nutrients by allowing water to drip slowly to the roots of plants, either from above the soil surface or buried below the surface.
A one-US-gallon-per-hour (3.8 L) drip flow controller feeding an 82-foot-long (25 m) drip line with check valves comprising 82 drip points along its length so each drip point is putting out about 1 / 82 US gallon (46 mL) per hour. Crimson clover sprouts grown on 1 / 8-inch (0.32 cm) urethane foam mats and flagstone.
Most drip tubes/tapes used in SSTI are pressure compensating. For example, using a 16mm drip tape, a run of up to 180 m can be achieved from one connection. Longer runs of up to 1,000 m can be achieved using lower flow rates per lineal metre and/or larger diameter drip tape. The following components make up a typical SSTI installation:
Drip irrigation layout and its parts. Drip irrigation, also known as microirrigation or trickle irrigation, functions as its name suggests. In this system, water is delivered at or near the root zone of plants, one drop at a time. This method can be the most water-efficient method of irrigation, [26] if managed properly; evaporation
The first experimental system of this type was established in 1959. In the early 1960s, Blass developed and patented this method and the new dripper was the first practical surface drip irrigation emitter. During the years 1960 to 1965 Blass developed the drip-irrigation systems and sold them inside Israel and abroad.
Driptech Inc. is a company engaged in making of irrigation-equipment, a type of drip irrigation method. The company won awards for its innovative, low cost drip irrigation system, eliminating expensive and complex emitters used by traditional drip irrigation systems. [1] The company is based out of Mountain View, California.
A satellite image of circular fields characteristic of center pivot irrigation, Kansas Farmland with circular pivot irrigation. Center-pivot irrigation (sometimes called central pivot irrigation), also called water-wheel and circle irrigation, is a method of crop irrigation in which equipment rotates around a pivot and crops are watered with sprinklers.
Micro-irrigation, also called Micro-spray,localized, low-volume, low-flow, or trickle irrigation, is an irrigation method with lower water pressure and flow than a traditional sprinkler system. Low-volume irrigation is used in agriculture for row crops , orchards , and vineyards .
Ad
related to: real life examples of drip irrigation methods in engineering