Search results
Results from the WOW.Com Content Network
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
Animated cut through diagram of a typical fuel injector, a device used to deliver fuel to the internal combustion engine. Fuels burn faster and more efficiently when they present a large surface area to the oxygen in air.
Aside from the belt/chain itself, also common is a failure of the tensioner, and/or the various gear and idler bearings, causing the belt/chain to derail. Furthermore, in engines where the timing belt drives the water pump, failure of the water pump can cause the pump to seize, which can break the timing belt or chain.
These engines vary in displacement between 2.8 and 3.4 litres (2,837 and 3,350 cc) and have a cast-iron block and either cast-iron or aluminum heads. Production of these engines began in 1980 and ended in 2005 in the U.S., with production continued in China until 2010. This engine family was the basis for the GM High Value engine family.
The Ford 385 engine family (also called "Lima" [2]) is a series of "big block" overhead valve (OHV) V8 engines designed and manufactured by Ford Motor Company.The family derives its 385 name from the 3.85-inch (98 mm) stroke of the 460 cubic-inch V8 introduced in 1968. [3]
The engine came with 543797 (4-barrel) and 9770716 heads for the tri-power and special exhaust manifolds and a 7H cam with 292deg. intake duration and later 1964 L with 288deg intake essentially the same as the 068 cam. #9770716 aka "716" heads featured a 170cc intake port volume, and were considered a milder "street" version of the vaunted ...
A crosshead as part of a reciprocating piston and slider-crank linkage mechanism. Cylindrical trunk guide Hudswell Clarke Nunlow; crosshead and two slide bars. In mechanical engineering, a crosshead [1] is a mechanical joint used as part of the slider-crank linkages of long stroke reciprocating engines (either internal combustion or steam) and reciprocating compressors [2] to eliminate ...
The Ford MEL is a big-block 90° V8 engine family produced in various configurations by the Ford Motor Company between 1958 and 1967 in displacements from 383–462 cubic inches (6.3–7.6 L), and used in Ford, Edsel, Mercury, and Lincoln vehicles.