enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   Introducing an additional bushing component between hub and shaft improves the performance and convenience of keyed joints. Taper-Lock bushings are keyed hub fittings which provide three threaded Dutch keyways and two setscrews as Dutch keys, in addition to the rectangular keyway. The Dutch keyways are threaded only on the alternate hub side or ...

3. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The rate of taper is 1:20 on diameter, in other words 0.600" on diameter per foot, .050" on diameter per inch. Tapers range from a Number 2 to a Number 20. The diameter of the big end in inches is always the taper size divided by 8, the small end is always the taper size divided by 10 and the length is the taper size divided by 2.

4. Taper pin - Wikipedia

   en.wikipedia.org/wiki/Taper_pin

   A taper pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end.

5. Drill bushing - Wikipedia

   en.wikipedia.org/wiki/Drill_bushing

   Customary bushings are specified using the following specification layout: [3] ID-Type-OD-Length. Where the ID is specified as a decimal, drill letter size, drill number size, or fraction; the OD is an integer that relates to a multiple of a 1 ⁄ 64 th of an inch (0.40 mm); the length is an integer that relates to a multiple of a 1 ⁄ 16 th

6. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   The most popular size is 8 mm which came in several variations but all 8 mm collets are interchangeable. Lorch, a German Lathe maker, started with 6 mm collets and the first Boleys used a 6.5 mm collet. 6 mm collets will fit into a 6.5 mm lathe but it is a poor practice. Another popular size is the 10 mm collet used by Clement and Levin.

7. Plain bearing - Wikipedia

   en.wikipedia.org/wiki/Plain_bearing

   A flanged bushing is a sleeve bushing with a flange at one end extending radially outward from the OD. The flange is used to positively locate the bushing when it is installed or to provide a thrust bearing surface. [9] Sleeve bearings of inch dimensions are almost exclusively dimensioned using the SAE numbering system.