enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Category 6 cable - Wikipedia

   en.wikipedia.org/wiki/Category_6_cable

   A Cat 6 patch cable, terminated with 8P8C modular connectors. Category 6 cable (Cat 6) is a standardized twisted pair cable for Ethernet and other network physical layers that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 must meet more stringent specifications for crosstalk and system noise than Cat 5 and ...

3. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs).

4. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   Cat-5: Energy-efficient Ethernet variant of 10BASE-T using a reduced amplitude signal over Category 5 cable, completely interoperable with 10BASE-T nodes. 10BASE-T1L: 802.3cg-2019 (146) IEC 63171-1, IEC 63171-6 1000 m Ethernet over a single twisted pair - long reach, for industrial applications 10BASE-T1S: 802.3cg-2019 (147) 25 m

5. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

6. Category:Ethernet cables - Wikipedia

   en.wikipedia.org/wiki/Category:Ethernet_cables

   Pages in category "Ethernet cables" The following 12 pages are in this category, out of 12 total. This list may not reflect recent changes. C. Category 3 cable;

7. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...