Ads
related to: main lug only vs mlo 6 cylinder mustang engine conversion
Search results
Results from the WOW.Com Content Network
The 1906–1908 Ford Model K luxury car used a 405 cu in (6.6 L) straight-six petrol engine and was the only Ford six-cylinder passenger car engine until the 1940s. The Ford flathead I6 was produced from 1941 until 1951, followed by the Ford OHV I6 overhead valve engine from 1952 through 1964, then the Ford Thriftpower Six overhead valve engine ...
The 250 cu in (4.1 L) inline-six engine was offered in 1969 in the Mustang, and 1970 in compact Ford cars (Maverick). The 250 was a stroked 200, made by increasing the stroke from 3.126 to 3.91 in (79.4 to 99.3 mm). Output was 155 hp (116 kW) in the Mustang, and the 250 became the base engine in 1971.
The Mach 1 was equipped with a 4.6 L DOHC 305 hp (227 kW) engine based on the engine available in the 1999 and 2001 Mustang Cobras, with new cylinder heads from the 2003 to 2004 Cobra (see above). The interior of the car was given a retro theme with seats made to look like the "comfort-weave" seats available in the 1960s-era Mach 1s.
Later models came with hydraulic clutches. These were commonly found in Pintos, some Mustang II/Capris, and Rangers but do not match the V6 Bell housings. Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines.
It came with a six-cylinder engine (250 cu in (4.1 L)), a high stall torque converter for the standard automatic transmission, and a low, 2.33:1 rear axle ratio. Mustang E lettering on the rear quarters identified the special Mustang E. [67] Air conditioning was not available on the 'E' model. [65]
The engine produces 435 horsepower (324 kW) at 6,500 rpm and 400 pound-feet (540 N⋅m) at 4,250 rpm—gains of 15 horsepower (11 kW) and 10 pound-feet (14 N⋅m) over the previous 5.0-liter. [81] The Mustang accelerates from zero to 60 mph (97 km/h) in 4.6 seconds and has a maximum speed of 155 miles per hour (249 km/h).
This engine used cast-iron cylinder liners and a cast-iron head. The cylinder heads for the two types of block (aluminum and cast iron) have similar designs but are not interchangeable. The cylinder head for the aluminum block is roughly 1/8" wider than that for the cast-iron block and uses a slightly different head bolt pattern. [9]
A V8 engine option would not be available in a Mustang for the only time for the 1974 model year (except in Mexico). "The Mustang II's attractive all-new styling was influenced by coachbuilder Ghia of Italy, which had recently been acquired by Ford. It carried through the long-hood, short-deck theme of the original, and — as Iacocca requested ...
Ads
related to: main lug only vs mlo 6 cylinder mustang engine conversion