Search results
Results from the WOW.Com Content Network
Placing the oil pump low-down uses a near-vertical drive shaft, driven by helical skew gears from the camshaft. Some engines, such as the Fiat Twin Cam engine of 1964, began as OHV engines with an oil pump driven from a conventional camshaft in the cylinder block. When the twin overhead cam engine was developed, the previous oil pump ...
The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found use in vehicles like the TrailBlazer SS, Saab 9-7X, and SSR.
Differential operation while driving in a straight line: Input torque is applied to the ring gear (purple), which rotates the carrier (purple) at the same speed. When the resistance from both wheels is the same, the planet gear (green) doesn't rotate on its axis (although the gear and its pin are orbiting due to being attached to the carrier).
The discontinued torque-tube drive was replaced by a new design utilizing an open driveshaft and a four-link axle-location system. [ 16 ] The 1961 Pontiac Tempest was introduced as a new model, featuring an inline 4 coupled to a transaxle via a torque tube, giving it a perfect 50-50 front-rear weight balance.
An electronic limited-slip differential will typically have a planetary or bevel gear set similar to that of an open differential and a clutch pack similar to that in a torque sensitive or gerotor pump based differential. In the electronic unit the clamping force on the clutch is controlled externally by a computer or other controller.
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
The first Ford company vehicle to use a Torsen differential was the 2002 Ford Ranger FX4, renamed in 2003+ years to FX4 Level II, all of which used T-2R in the rear differential only. Starting in 2012, the Ford F-150 SVT Raptor uses a front Torsen differential and the Ford Mustang Boss 302 uses a rear Torsen differential.
The oil collects in sump (1), is withdrawn continuously by scavenge pump (2) and travels to the oil tank (3), where gases entrained in the oil separate and the oil cools. Gases (6) are returned to the engine sump. Pressure pump (4) forces the de-gassed and cooled oil (5) back to the engine's lubrication points (7).