Search results
Results from the WOW.Com Content Network
The Standards Association of the Institute of Electrical and Electronics Engineers (IEEE) approved the Universal Power Adapter for Mobile Devices working group on June 17, 2010. [7] The project was sponsored by the Microprocessor Standards Committee of the IEEE Computer Society. On 15 May 2015 the standard was published as IEEE Std 1823-2015. [8]
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
In light of the declining popularity of the Micro USB connector and its limited power throughput relative to USB-C, in September 2021, the European Commission adopted a proposal to for a new directive, to update the existing Directive 2014/53/EU. [27] [28] The directive was approved by the European Parliament and Council of the European Union. [28]
However, the SuperSpeed USB part of the system still implements the one-lane Gen 1×1 operation mode. Therefore, two-lane operations, namely USB 3.2 Gen 1×2 (10 Gbit/s) and Gen 2×2 (20 Gbit/s), are only possible with Full-Featured USB-C. As of 2023, they are somewhat rarely implemented; Intel, however, started to include them in its 11th ...
Today, the parallel port interface is virtually non-existent in new computers because of the rise of Universal Serial Bus (USB) devices, along with network printing using Ethernet and Wi-Fi connected printers. The parallel port interface was originally known as the Parallel Printer Adapter on IBM PC-compatible computers.
USB 3.0 is the third major version of the Universal Serial Bus (USB) standard for interfacing computers and electronic devices. Among other improvements, USB 3.0 adds the new transfer rate referred to as SuperSpeed USB (SS) that can transfer data at up to 5 Gbit/s (625 MB/s), which is about 10 times faster than the USB 2.0 standard.
The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5] USB 3.0 connectors are generally backward compatible, but include new wiring and full-duplex operation.
eSATAp throughput is not necessarily the same as SATA, many enclosures and docks that support both eSATA and USB use combo bridge chips which can severely reduce the throughput, and USB throughput is that of the USB version supported by the port (typically USB 3.0 or 2.0). eSATAp ports (bracket versions [clarification needed]) can run at a ...