Search results
Results from the WOW.Com Content Network
Prior to the development of integrated read-only memory (ROM) circuits, permanent (or read-only) random-access memory was often constructed using diode matrices driven by address decoders, or specially wound core rope memory planes. [citation needed] Semiconductor memory appeared in the 1960s with bipolar memory, which used bipolar transistors ...
Read-only memory (ROM) is a type of non-volatile memory used in computers and other electronic devices. Data stored in ROM cannot be electronically modified after the manufacture of the memory device. Read-only memory is useful for storing software that is rarely changed during the life of the system, also known as firmware.
Read–write memory, or RWM, is a type of computer memory that can be easily written to as well as read from using electrical signaling normally associated with running a software, and without any other physical processes.
Ferroelectric RAM (FeRAM, F-RAM or FRAM) is a random-access memory similar in construction to DRAM but using a ferroelectric layer instead of a dielectric layer to achieve non-volatility. FeRAM is one of a growing number of alternative non-volatile random-access memory technologies that offer the same functionality as flash memory .
To date, the only such system to enter widespread production is ferroelectric RAM, or F-RAM (sometimes referred to as FeRAM). F-RAM is a random-access memory similar in construction to DRAM but (instead of a dielectric layer like in DRAM) contains a thin ferroelectric film of lead zirconate titanate [Pb(Zr,Ti)O 3], commonly referred to as PZT ...
RAM (Random-access memory) – This has become a generic term for any semiconductor memory that can be written to, as well as read from, in contrast to ROM (below), which can only be read. All semiconductor memory, not just RAM, has the property of random access. DRAM (Dynamic random-access memory) – This uses memory cells consisting of one ...
Many modern GPUs rely on VRAM. In contrast, a GPU that does not use VRAM, and relies instead on system RAM, is said to have a unified memory architecture, or shared graphics memory. System RAM and VRAM have been segregated due to the bandwidth requirements of GPUs, [2] [3] and to achieve lower latency, since VRAM is physically closer to the GPU ...
It is the read-write memory directly addressable by the processor for use by the operating system and application programs. As memory prices rapidly declined, this design decision became a limitation in the use of large memory capacities until the introduction of operating systems and processors that made it irrelevant.