enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tribrach (instrument) - Wikipedia

   en.wikipedia.org/wiki/Tribrach_(instrument)

   The centre of the bottom plate of the tribrach has a 5/8-11 UNC thread bolt hole which is used to attach the tribrach to the tripod. The top plate has three small holes or slots spaced 120˚ apart above leveling thumbscrews, and a locking mechanism which enables a survey instrument or target to be accurately placed on the tribrach and locked in ...

3. Tripod (surveying) - Wikipedia

   en.wikipedia.org/wiki/Tripod_(surveying)

   A surveyor's tripod with a shoulder strap. The head of the tripod supports the instrument while the feet are spiked to anchor the tripod to the ground. A surveyor's tripod is a device used to support any one of a number of surveying instruments , such as theodolites , total stations , levels or transits.

4. North American Charging System - Wikipedia

   en.wikipedia.org/wiki/North_American_Charging_System

   The North American Charging System (NACS), standardized as SAE J3400, is an electric vehicle (EV) charging connector standard maintained by SAE International. [1] Developed by Tesla, Inc. , it has been used by all North American market Tesla vehicles since 2021 and was opened for use by other manufacturers in November 2022.

5. List of surveying instruments - Wikipedia

   en.wikipedia.org/wiki/List_of_surveying_instruments

   Help; Learn to edit; Community portal; Recent changes; Upload file; Special pages

6. Charging station - Wikipedia

   en.wikipedia.org/wiki/Charging_station

   Case A: any charger connected to the mains (the mains supply cable is usually attached to the charger) usually associated with modes 1 or 2. Case B: an on-board vehicle charger with a mains supply cable that can be detached from both the supply and the vehicle – usually mode 3. Case C: DC dedicated charging station. The mains supply cable may ...

7. Battery holder - Wikipedia

   en.wikipedia.org/wiki/Battery_holder

   Battery types such as the 9-volt have snap-on contacts. Battery holders for zinc-air batteries must not be completely air-tight since approximately 1 litre of air is required per ampere-hour of discharge per cell. The battery holder may include a valve integrated with the device power switch to allow air to be admitted when the device is ...

8. AN/PVS-4 - Wikipedia

   en.wikipedia.org/wiki/AN/PVS-4

   Later designations such as the AN/PVS-4A use two common AA batteries (BA-3058/U) via a purpose-built adapter (PN A3009873) that attaches to one of the circular battery compartments. Use of the adapter negates the need for BA-5567/U and BA-3058/U. AN/PVS-4s still in use today are typically upgraded with the AA battery adapter even if they have ...

9. Magne Charge - Wikipedia

   en.wikipedia.org/wiki/Magne_Charge

   The Magne Charge inductive charger was developed by General Motors subsidiary Delco Electronics, based on SAE recommended practice J1773 [3] for electric passenger vehicles, primarily GM products such as the EV1 and the Chevy S10 EV, however, the Nissan Altra and the first generation Toyota RAV4 EV also used the charger. [4]