Search results
Results from the WOW.Com Content Network
00000000000 2 =000 16 is used to represent a signed zero (if F = 0) and subnormal numbers (if F ≠ 0); and; 11111111111 2 =7ff 16 is used to represent ∞ (if F = 0) and NaNs (if F ≠ 0), where F is the fractional part of the significand. All bit patterns are valid encoding. Except for the above exceptions, the entire double-precision number ...
The double hyphen is used for several different purposes throughout the world: Some typefaces, such as Fraktur faces, use the double hyphen as a glyphic variant of the single hyphen. (With Fraktur faces, such a double hyphen is usually oblique.) It may be also used for artistic or commercial purposes to achieve a distinctive visual effect.
For numbers with a base-2 exponent part of 0, i.e. numbers with an absolute value higher than or equal to 1 but lower than 2, an ULP is exactly 2 −23 or about 10 −7 in single precision, and exactly 2 −53 or about 10 −16 in double precision. The mandated behavior of IEEE-compliant hardware is that the result be within one-half of a ULP.
The range of a double-double remains essentially the same as the double-precision format because the exponent has still 11 bits, [4] significantly lower than the 15-bit exponent of IEEE quadruple precision (a range of 1.8 × 10 308 for double-double versus 1.2 × 10 4932 for binary128).
Here we start with 0 in single precision (binary32) and repeatedly add 1 until the operation does not change the value. Since the significand for a single-precision number contains 24 bits, the first integer that is not exactly representable is 2 24 +1, and this value rounds to 2 24 in round to nearest, ties to even. Thus the result is equal to ...
FLT_MANT_DIG, DBL_MANT_DIG, LDBL_MANT_DIG – number of FLT_RADIX-base digits in the floating-point significand for types float, double, long double, respectively; FLT_MIN_EXP, DBL_MIN_EXP, LDBL_MIN_EXP – minimum negative integer such that FLT_RADIX raised to a power one less than that number is a normalized float, double, long double ...
A simple method to add floating-point numbers is to first represent them with the same exponent. In the example below, the second number is shifted right by 3 digits. We proceed with the usual addition method: The following example is decimal, which simply means the base is 10. 123456.7 = 1.234567 × 10 5 101.7654 = 1.017654 × 10 2 = 0. ...
In CORBA (from specification of 3.0, which uses "ANSI/IEEE Standard 754-1985" as its reference), "the long double data type represents an IEEE double-extended floating-point number, which has an exponent of at least 15 bits in length and a signed fraction of at least 64 bits", with GIOP/IIOP CDR, whose floating-point types "exactly follow the ...