Search results
Results from the WOW.Com Content Network
The heat pipe is mainly used in space, process or air heating, in waste heat from a process is being transferred to the surrounding due to its transfer mechanism. Thermal wheel or rotary heat exchanger: consists of a circular honeycomb matrix of heat absorbing material, which is slowly rotated within the supply and exhaust air streams of an air ...
An oil burner is a part attached to an oil furnace, water heater, or boiler. [1] It provides the ignition of heating oil/biodiesel fuel used to heat either air or water via a heat exchanger . The fuel is atomized into a fine spray usually by forcing it under pressure through a nozzle which gives the resulting flame a specific flow rate, angle ...
three-drum boiler: water-tube boilers with three drums in a triangular arrangement. The best known of these are the Yarrow and Admiralty patterns. Lesser-known examples are the Normand and Mumford. Thornycroft boiler: Several variants of an early naval water-tube boiler. [6] [9] [59] Also a small annular water-tube boiler used in Thornycroft's ...
Small examples of the O-type are used as some package boilers. [2] Most package boilers are fire-tube boilers, often used for heating or process steam, and generally work at lower pressures than propulsion boilers. If high pressure steam is needed, such as for steam turbines, then a water-tube boiler may be preferred and these are mostly O-type ...
When recycling water from a bath (100–150 litres) or shower (50–80 litres) the waste water temperature is circa 20–25 °C. An in-house greywater recycling tank holds 150–175 litres allowing for the majority of waste water to be stored. Utilizing a built in copper heat exchange with circulation pump the residual heat is recovered and ...
One advantage of a boiler is that the furnace can provide hot water for bathing and washing dishes, rather than requiring a separate water heater. One disadvantage to this type of application is when the boiler breaks down, neither heating nor domestic hot water are available. Air convection heating systems have been in use for over a century.
The back boiler is typically used with a gravity feed circuit to the hot water cylinder, with a vent or overflow to prevent excess pressure build up.It can also be connected to a series of radiators to provide central heating but usually requires an electrical pump to be fitted to circulate the hot water, some systems can use the gravity circuit to include radiators.
A heat exchanger brings the heat from the burner to the water. Its job is to bring heat to the water without having contact with the water, similar to boiling water in a pot. An exhaust stack takes the hot gases and transfers them away from the boiler. Boiler controls are there to make sure the hot water or steam is produced in a safe way. [5]