Search results
Results from the WOW.Com Content Network
A rollover cable (also known as a Yost cable, Cisco cable, or a console cable) is a type of null-modem cable that is used to connect a computer terminal to a router's console port. This cable is typically flat (and has a light blue color) to help distinguish it from other types of network cabling.
The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15) Became a nearly ubiquitous analog computer display connector after first being introduced with IBM x86 machines. Older VGA connectors were DE-9 (9-pin).
It is based on RS-232 serial communications at 9600 bit/s, 8N1, no flow control typically though a DE-9 connector, but can also be on 8-Pin DIN, RJ45 and RJ11 connectors used in daisy chain configurations. [1] VISCA utilizes a serial repeater network configuration to communicate between the PC (device #0) and up to 7 peripherals (#1 through #7).
A Cisco rollover cable using the 8P8C Yost standard. 8P8C connectors are also used in many devices. The EIA/TIA-561 standard defines a pinout using this connector, while the rollover cable (or Yost standard) is commonly used on Unix computers and network devices, such as equipment from Cisco Systems. [7]
GG45 (GigaGate 45) and ARJ45 (Augmented RJ45) are two related connectors for Category 7, Category 7 A, and Category 8 telecommunication cabling. The GG45 interface and related implementations are developed and sold by Nexans S.A. , while the ARJ45 interface and related implementations are developed and sold by Bel Fuse Inc.
Serial cables are typically used for RS-232 communication.. A serial cable or RS-232 cable is a cable used to transfer information between two devices using a serial communication protocol.
Using the same wiring scheme at each end yields a straight-through cable (a given color wire connects to a given number pin, the same at both ends). In this case, the terminations are identical, so only one pinout is required. In a crossover cable, pins do not correspond – some or all of the conductors are swapped at the terminations.
The RJ45S jack is rarely used in telephone applications, and the keyed 8P8C modular plug used for RJ45S mechanically cannot be inserted into an Ethernet port, but a similar plug, the non-keyed 8P8C modular plug – never used for RJ45S – is used in Ethernet networks, and the connector is often, however improperly, referred to as RJ45 in this ...