Ads
related to: sata cable to power supply chargerebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
A version of this wide connector is found inside every external SATA hard drive enclosure; when the hard drive is slid inside, it mates with a connector that supplies it with both signal and power. If the smaller side of this cable is plugged into a "powered" ESATA port, providing both 12 V and 5 V, then the wide end may be plugged into a 2.5 ...
Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data. [a] An additional cable was used for power, initially frequently AC but later usually connected directly to a DC power supply unit. The controller provided ...
The DC power supplies to a hot-swap component are usually pre-charged by dedicated long pins that make contact before the main power pins. These pre-charge pins are protected by a circuit that limits the inrush current to an acceptable value that cannot damage the pins nor disturb the supply voltage to adjacent slots. The pre-charge circuit ...
In some cases, though, the host adapter end of the cable would use a different connector. For example, in the Sun 260 series chassis (used for the Sun 3/260 and Sun 4/260 computers), the connector was the same 3-row 96-pin connector used to attach peripheral cards to the VMEbus backplane .
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [1]
Ads
related to: sata cable to power supply chargerebay.com has been visited by 1M+ users in the past month