Search results
Results from the WOW.Com Content Network
[1] [2] For example, a descent from flight level 350 would require approximately 35x3=105 nautical miles. This would have to be adjusted for headwind or tailwind, [1] and also to allow for deceleration time. Alternatively, David P. Davies gives the rule as 300 feet of descent required for each nautical mile of distance. [3]: 176
The top of descent is usually calculated by an on-board flight management system, and is designed to provide the most economical descent to approach altitude, or to meet some other objective (fastest descent, greatest range, etc.). The top of descent may be calculated manually as long as distance, air speed, and
The performance data for landing an aircraft can be obtained from the aircraft's flight manual or pilot's operating handbook. It will state the distance required to bring the aircraft to a stop under ideal conditions, assuming the aircraft crosses the runway threshold at a height of 50 ft, at the correct speed.
The maximal total range is the maximum distance an aircraft can fly between takeoff and landing. Powered aircraft range is limited by the aviation fuel energy storage capacity (chemical or electrical) considering both weight and volume limits. [1] Unpowered aircraft range depends on factors such as cross-country speed and environmental conditions.
The maximum landing weight (MLW), also known as the maximum structural landing weight or maximum structural landing mass, [1] is the maximum aircraft gross weight due to design or operational limitations at which an aircraft is permitted to land. The MLW is set in order to ensure safe landings; if an aircraft weighs too heavy during touchdown ...
Steeper approaches require a longer landing distance, which reduces runway throughout at busy airports, and requires longer taxi distances. Airports such as Heathrow and London Luton are trialling slightly steeper approaches (3.2°) to reduce noise, by keeping the aircraft higher for longer and reducing engine power required during descent.
The location of the reference datum is established by the manufacturer and is defined in the aircraft flight manual. The horizontal reference datum is an imaginary vertical plane or point, placed along the longitudinal axis of the aircraft, from which all horizontal distances are measured for weight and balance purposes.
Few flight planning systems calculate the actual takeoff weight; instead, the fuel used for taking off is counted as part of the fuel used for climbing up to the normal cruise height. Landing weight is the weight of an aircraft as it lands at the destination. This is the brake release weight minus the trip fuel burned.