Search results
Results from the WOW.Com Content Network
A series circuit with a voltage source (such as a battery, or in this case a cell) and three resistance units. Two-terminal components and electrical networks can be connected in series or parallel. The resulting electrical network will have two terminals, and itself can participate in a series or parallel topology.
A speaker L pad is a special configuration of rheostats used to control volume while maintaining a constant load impedance on the output of the audio amplifier. [1] It consists of a parallel and a series rheostat connected in an "L" configuration.
This can be done by wiring the speakers in series, as opposed to parallel (though if the impedance is too high, power transfer is inefficient), with impedance-matching transformers, or by using constant-voltage transformers (often, 70 volts). These systems are commonly employed in retail environments and large buildings such as churches, where ...
The electrical impedance of the speaker varies with the back EMF and thus with the applied frequency. The impedance is at its maximum at F s , shown as Z max in the graph. For frequencies just below resonance, the impedance rises rapidly as the frequency increases towards F s and is inductive in nature.
Whether speakers are wired in parallel or in series affects the impedance of the system. Two 8 ohm speakers wired in parallel have 4-ohm impedance. Guitarists who connect multiple cabinets to an amplifier must consider the amp's minimum impedance. Parallel vs. series also affects tone and sound. Speakers wired in parallel slightly dampen[s] and ...
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
Parallel vs. Series Hybrids: ... The battery acts as a buffer, so the generator can operate at its most productive speeds—meaning it may not run from 600 to 6000 rpm, as an engine that powers ...
Equivalent unbalanced and balanced networks. The impedance of the series elements in the balanced version is half the corresponding impedance of the unbalanced version. Fig. 3. To be balanced, a network must have the same impedance in each "leg" of the circuit. A 3-terminal network can also be used as a 2-port.