Search results
Results from the WOW.Com Content Network
Private addresses are also commonly used in corporate networks which, for security reasons, are not connected directly to the Internet. Often a proxy, SOCKS gateway, or similar devices are used to provide restricted Internet access to network-internal users. Private network addresses are not allocated to any specific organization.
In 2012 the complexity of breaking MS-CHAPv2 was reduced to that of breaking a single DES key (work by Moxie Marlinspike and Marsh Ray). Moxie advised: "Enterprises who are depending on the mutual authentication properties of MS-CHAPv2 for connection to their WPA2 Radius servers should immediately start migrating to something else."
Wi-Fi positioning system (WPS, WiPS or WFPS) is a geolocation system that uses the characteristics of nearby Wi‑Fi access points to discover where a device is located. [1]It is used where satellite navigation such as GPS is inadequate due to various causes including multipath and signal blockage indoors, or where acquiring a satellite fix would take too long.
Wireless security is another aspect of computer security. Organizations may be particularly vulnerable to security breaches [6] caused by rogue access points.. If an employee adds a wireless interface to an unsecured port of a system, they may create a breach in network security that would allow access to confidential materials.
This is a list of countries by IPv4 address allocation.. The Internet Assigned Numbers Authority (IANA) distributes large blocks of addresses to regional Internet registries (RIRs), which then assign them to national Internet registries and local Internet registries within their respective service regions. [1]
A successful ARP spoofing (poisoning) attack allows an attacker to alter routing on a network, effectively allowing for a man-in-the-middle attack.. In computer networking, ARP spoofing (also ARP cache poisoning or ARP poison routing) is a technique by which an attacker sends Address Resolution Protocol (ARP) messages onto a local area network.
The first and last address in any network or subnet is not allowed to be assigned to any individual host. In the past, the recommended allocation for an IPv6 customer site was an address space with a 48-bit (/ 48) prefix. [20] However, this recommendation was revised to encourage smaller blocks, for example using 56-bit prefixes. [21]
IPv6 does not implement broadcast addressing. Broadcast's traditional role is subsumed by multicast addressing to the all-nodes link-local multicast group ff02::1. However, the use of the all-nodes group is not recommended, and most IPv6 protocols use protocol-specific link-local multicast groups to avoid disturbing every interface on a given ...